

Now lets compile and see if it works. I assume you know how rudder should work (which way it turns when you turn the plane). If not, consult any flightsimulator or check out the official planes. The problem when making axises for plane surfaces, is that the order teh vertices in the axis is created matters! So sometimes you might end up with a surface, like the rudder, going the wrong way or spinning around like crazy. If the rudder is reversed when you compile now, simply swap the axis vertices position to fix it (that way you have rotated the axis 180* and it should now work). The axis swapping need is a common problem with plane makers, so be prepared to swap some axis points if the problem occurs.

How the rudder should work. If it is reversed, try swapping the two axis points.
The most common problem with plane surfaces is Typos, its so damn easy to make a mistake when typing the selection names (much due to the words left and right in czech ihas different forms; levy (left); leve, leva, and pravy; (right) prave, prava, etc. So make sure you get all of the selection names right!
Now compile and test it ingame. Remember to swap (switch places) on axis vertices if one of the elevators go the wrong way when testing. If you are unsure, compare to another plane or try thinking of what happens when a surface moves.
Go to 0.00 lod and make the alierons. But this time, make a total of 4 structures, not just one pair as before. Remember the airbrake on the A10? Of not, test it now and try to imagine how they did it. Basically, they have splitted each alieron surface in two, so that when normal flying it works jsut as a normal alierons, but when you brake (holding the back-key long enough), they split parts, with one part going up and one down to form the airbrakes. Pretty neat, really.
Here is a setup for airbrakes from another model of mine. Just to show you how it all works. Dont worry, I`ll walk you trough the whole selection naming.
So lets do this:
Now you have two alierons, one right and one left both split on two halves. Now we must create proper selections for them.
Phew, now that was a bit hard, now wasnt it? Test it and correct with axis swapping or typo hunt if you screwed up. Make sure you get it right: When a plane bank (roll) to the left, the one on your left goes up and the one on the right goes down (seen from the back). And vice versa. Also, test the airbrake feature: when you hold down the back-button for some time, the alierons should split and the top pair goes up (+90 degrees up) and the bottom pair goes down (-90 degrees down). Compare with the A10 if you are still unsure.
Here showing how alierons with airbrakes work.
Now test the flaps ingame. Operate them using the action menu and make sure they move the right way. if not, you know what to do dont you ;)?

Flaps in the up and down positions.
Ok, still alive? Good, because we are all done with control surfaces! So now they work, the propeller spins and the gear retracts. Great job! On the next page we`ll add some more detail, and then its all done!
Back__Home__Next